Sonifex: S2 Stereo Line & Gram Channel
Ships in 3-5 days
S2-CSG Stereo Line & GramChannel
The S2-CSG channel is the dual stereo line channel fitted with an RIAA input amplifier on the second input. The balanced stereo line input is on Neutrik XLR connectors and the unbalanced RIAA stereo input on phonos.
The channel is used for connecting a turntable or record deck. The GRAM inputs have RIAA equalisation suitable for magnetic pick-up cartridges.
Selecting the LINE/GRAM button switches the channel input between Stereo Line and RIAA . The button is illuminated in red to indicate when Gram (RIAA) is selected. The operation of the button is inhibited when the channel is “live”.
There are separate logic remote output controls for both of the two inputs providing start/stop functions by fader, or ON button. Remotes, etc, are triggered when the fader is up and the channel ON button shows green. The start function can be configured to be either momentary (500mS) or latched for each input. The remote outputs on the 9 way D-type plug are fed from NPN opto-isolators.
Continuous momentary start can be enabled such that when the fader is up and the channel is on, each press of the ON button triggers a momentary start.
Two remote pins can also be configured for general use as either inputs, outputs, latching, or momentary and active high or low. Uses for this include channel live indication or specific channel function remote control.
The BAL/PAN control adjusts the stereo balance in the following manner : Full anti-clockwise shifts the signal to the left and increases the signal by 6dB (right channel reduces by 6dB); full clockwise shifts the signal to the right and increases the signal by 6dB (left channel reduces by 6dB).
The 100mm VCA fader provides unity gain when fully open. The channel input signal is routed to the outputs whenever the fader is open, the ON button is selected and either or both of the routing buttons are selected.
|Mic Input:||> 1k5O electronically balanced|
|Mono Line Input:||> 20kO electronically balanced|
|Stereo Line Input:||> 20kO electronically balanced|
|PGM & AUD Output:||< 75O electronically balanced|
|Mono Output:||< 75O electronically balanced|
|Monitor Outputs:||< 75O unbalanced|
|BNC Wordclock input:||50O|
Input/Output Gain Range
|Mic Input:||Preset pot +13dB to +66dB ref -50dBu, TRIM pot ±12dB|
|Mono Line Input:||Preset pot -6dB to +10dB ref 0dBu, TRIM pot ±12dB|
|Stereo Line Input:||Preset pot -6dB to +10dB ref 0dBu, TRIM pot ±12dB|
|Telco Input:||Preset pot -6dB to +10dB ref 0dBu, TRIM pot ±12dB|
|Telco Output:||Preset pot -6dB to +4dB ref 0dBu|
|Mix Minus Input:||Preset pot -6dB to +10dB ref 0dBu, TRIM pot ±12dB|
|Mix Minus Output:||Preset pot -3dB to +3dB ref 0dBu|
|Digital Input:||0dBFS = +12dBu on input; TRIM pot ±12dB allowing 0dBu to +24dBu|
|Digital Output:||0dBFS = +18dBu|
|Mic Input:||40Hz to 20kHz, -1dB,+0dB (-3dB at 130Hz with HPF in)|
|Line Inputs:||20Hz to 20kHz, - 0.5dB,+0dB|
|RIAA Input:||30Hz to 16kHz ±1.5dB RIAA equalised|
Noise (20Hz to 20kHz)
|Mic Input E.I.N.:||-129dB with 150O source|
|Stereo Inputs (fader down, no routing):||-89dB ref 0dB|
|Stereo Inputs (fader down, one channel routed):||-89dB|
|Stereo Inputs (unity gain, no routing):||-89dB|
|Stereo Inputs (unity gain, one channel routed):||-86dB|
|Stereo Inputs (unity gain, two channels routed):||-83dB|
|Total Harmonic Distortion:||0.015% at 1kHz, 0dB|
0.025% at 10kHz, 0dB
|Stereo:||-90dBu at 1kHz|
|LF Shelving at 100Hz:||±7dB|
|HF Shelving at 6.5kHz:||±7dB |
|Pan Range:||off/-3dB centre/off|
Common Mode Rejection Ratio
|Mic Input:||> 100dB at 70dB gain|
|Sync Input Sample Rate:||30kHz - 100kHz|
|Output Sample Rates (Using Onboard Clock):
||32kHz, 44.1kHz, 48kHz, & 96kHz|
|Output Sample Width:||16, 20, 24 bit (24 bit on V2 ODA/ODP)|
|Headphone Output Load:||>45O, 400O recommended|
|Maximum Output (Analogue):||+26dBu balanced into 2kO or greater|
|Power (S2-PSU):||Filtered IEC, switchable 115V, 230V, fused, 210W max.|
|48cm (W) x 24.3cm (D) x 8.8cm (H)|
19” (W) x 10” (D) x 3.5” (H)
|51cm (W) x 41.5cm (D) x 17cm (H)|
20” (W) x 16.3” (D) x 6.7” (H)
|Weight (S2-PSU):||Nett: 6kg Gross: 7.8kg|
Nett: 13.2lbs Gross: 17lbs
|48cm (W) x 23cm (D) x 4.4cm (H)|
19” (W) x 9” (D) x 1.7” (H)
|55cm (W) x 39.3cm (D) x 8.5cm (H)|
21.6” (W) x 15.5” (D) x 3.4” (H)
|Weight (S2-PSUS):||Nett: 1.58kg Gross: 2kg|
Nett: 3.5lbs Gross: 4.4lbs